Table of Contents
Advertisement
To Install the Y-Rack
1. Carefully lay the quilting machine on the left side,
(looking from the front).
Underneath the base plates, near the wheels on the
right side of the machine (the side with the thread
tensioner and guides) there will be either two screws
or two holes. If the screws are there, use a large flat
screwdriver to remove the screws.
2. Attach the Y-Rack to the bottom of the front and rear
base plates. The blue Flexirack should be toward the
middle of the machine while the bolt holes should
be toward the outside. Use the screws that were
removed from the front and rear base plates. Use
the two screws from the baseplate that fit best.
[See Parts List, item D]
U CAUTION: Be careful not to over-tighten the
screws as the base plate holes will strip easily.
14 | Installation Instructions
www.Janome.com
Hide quick links:
Advertisement
Table of Contents
