Table of Contents
Advertisement
Chapter 5 Parameter Menus
Operational Parameters
The LS 4071 is shipped with the default settings beginning on page 5-2. These
default values are stored in non-volatile memory and are preserved even when
the scanner is powered down. You can change these default values by scanning
the appropriate bar codes included in this manual. These new values replace
the standard default values in memory. The default parameter values can be
recalled by scanning the SET ALL DEFAULTS bar code on page 5-7.
Even if the default parameters suit your needs, you still must select a terminal
type. The base automatically identifies the host type on power-up. It makes this
determination provided the host is powered-up before the base is attached to
it. You must then select the appropriate terminal type for that host. For
example, if the base is connected to an IBM 4683, after you hear the power-up
beeps, you must then select the proper port. The same applies to all other host
types.
5-1
Advertisement
Table of Contents
