Mitsubishi Electric MELSEC Q Series User Manual page 47

3 SPECIFICATIONS
Device No. Signal name
Offset/gain setting
XA
mode flag
Channel change
XB
completed flag
3 - 21
[In offset/gain setting mode]
(1) This is used as an interlock condition for setting User range writing request (YA) to
on/off when registering the value after adjustment of the offset/gain settings have
been completed.
(2) Refer to Section 4.6 regarding the offset/gain settings.
Module ready (X0)
Offset/gain setting mode flag (XA)
User range write request (YA)
[In normal mode]
(1) This signal is used as an interlock condition to run on/off User range writing request
(YA) when the user range is restored.
(2) Refer to Chapter 7 regarding the user range restoration.
Module ready (X0)
Offset/gain setting mode flag (XA)
User range writing request (YA)
(1) This is used as an interlock condition for turning on/off Channel change request
(YB) when changing the channel where offset/gain settings will be performed or
changing the offset/gain range settings.
(2) Refer to Section 4.6 regarding the offset/gain settings.
Offset/gain setting mode
Offset/gain specifications
(buffer memory addresses 22 and 23:
Un\G22 and Un\G23)
Offset/gain range setting
(buffer memory addresses 25: Un\G25)
Channel change completed
flag (XB)
Channel change request (YB)
Description
Performed by the Q62DA-FG
Performed by the sequence program
OFF
Performed by the Q62DA-FG
Performed by the sequence program
ON
Performed by the Q62DA-FG
Performed by the sequence program
MELSEC-Q
3 - 21