Mitsubishi Electric MELSEC Q Series User Manual page 119

6 PROGRAMMING
Write digital values
Set analog output enable
Read disconnection detection flag
Read warning output flag
Error code display and reset processing
6 - 9
(3) Programming example
POINT
To write the intelligent function module parameters, set the target remote I/O
station from [Online] - [Transfer setup] on GX Developer.
They can be written by:
• Directly connecting GX Developer to the remote I/O station.
• Connecting GX Developer to another device such as a CPU module and
passing through the network.
Processing for disconnection detection
Processing for warning output
Processing for warning output
MELSEC-Q
CH1 Digital value setting
CH2 Digital value setting
CH1 Output enable
CH2 Output enable
Disconnection detection
channel check
Processing for CH1
disconnection detection
Disconnection detection clear
request (YD) on
Disconnection detection clear
request (YD) off
Warning output channel check
CH2 Warning output
(upper limit value) processing
CH2 Warning output
(lower limit value) processing
Warning output clear request
(YE) on
Warning output clear request
(YE) off
Error code output in BCD
Error clear request (YF) on
Error clear request (YF) off
6 - 9