Incorporated Safety.devices - Saeco Royal SUP 016 User's And Maintenance Booklet

82
When the fluid has reached the desired tempera-
ture, close the knob and immediately clean the
spout with a damp cloth. Attention: the spout is
hot, it may cause burns I
Cappuccino
Through the special Cappuccinatore, this ma-
chine can brew a real cappuccino without any
problem.
By pressing the cappuccino button, these two
messages will be alternately displayed:
CAPPUCCINO
READY FOR USE
SELECT PRODUCT
READY FOR USE
That is because the machine, as mentioned
before, can dispense two products at the same
time.
INCORPORATED
SAFETY DEVICES
During the cappuccino dispensing, only the
programmed amount is dispensed if the corre-
sponding programming is enabled. On the
contrary, dispensing should be stopped by press-
ing again the selection key when the desired
cappuccino amount has been reached. To
program the cappuccino amount, it is necessary
to keep the corresponding selection key pressed
till the desired amount is reached.
Attention: cappuccino amount can only be
programmed if the
programming function is enabled (see page
76).
For cappuccino dispensing, fit suction pipe (26)
of the Cappuccinatore (25| in a milk container
or in another container. To prevent milk container
deformation, pierce it on the top to allow air
entry.
Place the cup under dispenser (27) and press the
cappuccino selection key.
Cappuccino dispensing can be adjusted by
turning the special Cappuccinatore adjustment
.live (28).
Note: it is suggested to use milk with low fat
amounts (1 .5°o|.
Cappuccinatore cleaning
Let the Cappuccinatore drain a full water con-
tainer after each cappuccino dispensing: in this
way, the device will be perfectly cleaned.
Incorporated safety devices
Automatic off
Should the service door be open, the machine
automatically switches off. If the central unit is nol
mounted, only water and steam can be dis-
pensed.
Electronic grinding time control
As soon as the coffee bean container is empty,
grinding automatically stops after 20 seconds
approx. Fill the container with coffee beans, as
shown at page 73.
Electronic pump control
The machine switches off automatically as soon
as the water in the tank is under the minimum
level checked by a special water level indicator
(73). Fill the tank according to the procedure
shown at page 73.
Electronic temperature adjustment
Said adjustment controls the correct temperature
to brew coffee and to dispense hot water and
steam.
Coffee brewing
should the water temperature be excessive
(safety thermostat and overheating safety device
activated).
corresponding
Antigravel device
Even selected coffees may contain impurities. To
avoid damages, the coffee grinder is fitted with
an antigiavel device against impurities. Should
gravel end up into the coffee grinder, you will
hear a strong and characteristic noise. Stop the
machine immediately otherwise the machine will
automatically stop within 20 seconds-thanks to
the special electronic protection system.
SAFETY DEVICES
is automatically interrupted