Incorporated Safety Devices - Saeco SUP 015 User's And Maintenance Booklet

21
Coffee beans
29
This machine grinds a portion of fresh coffee for
each cup; for two cups, it grinds two portions of
coffee, one after the other thus ensuring opti-
mum coffee quality.
Before any use, make sure the steam/hot water
knob is closed.
Adjust the desired grinding degree: the recom-
mended average value is 5.
The grinding degree must be adjusted only
when the coffee grinder is operating, otherwise
it may be damaged.
Place one or two preheated cups on the grill (3)
under the dispenser (6). Press the relevant
selection key. The machine will automatically
dispense the selected coffee.
The coffee flow may be stopped at any moment
by pressing any selection button (except the
standby switch), for instance when an excessive
quantity of water has been selected. Should you
interrupt the coffee flow after the first of two
coffees has been brewed, the second is not
dispensed.
Pre-ground coffee
Make sure to use pre-ground coffee only (me-
dium ground). Never use whole beans or
soluble coffee!
Right before making coffee, fill the container
BREWING
with freshly ground coffee. Remember that
ground coffee ages soon, thus losing its quality.
30
Use the measuring spoon supplied to fill the
container (14) with ground coffee. Use a full
measure only.
Then, press the pre-ground coffee selection
button and the desired selection key (regu-
lar, espresso or tall coffee) to obtain a cup of
coffee. It is not possible to obtain a second cup
of coffee.
The coffee flow may be stopped at any moment
by pressing any selection button (except the
standby switch), for instance when an excessive
quantity of water has been selected.
Hot water
The hot water dispensing is separate from the
coffee circuit, in order to supply tasteless hot
water for tea, soup etc.
31
Place a glass or cup under the steam/hot water
dispensing tube (7), then slowly open knob (9),
turning it counterclockwise. Hot water will be
automatically dispensed. As soon as dispens-
ing is over, close knob again.
Steam
To heat milk or other drinks.
Clean the spout with a damp cloth soon after
use; otherwise, it might be difficult to remove
milk residues.
After a steam outflow, always drain the ma-
chine. If the machine is not drained or drained
22
partially, the coffee brewing program automati-
cally stops, due to excessive temperature.
If the machine is on the steam mode , the
automatic coffee brewing is prevented.
"STEAM
"WARMING UP...... "
Press the steam selection button and wait
until the machine reaches the operating tem-
perature.
"STEAM
"READY FOR USE
Operating temperature has been reached.
Direct the steam/hot water dispensing tube (7)
over the cup holder grill (3) and slightly open
knob (9), turning it counterclockwise.
Wait until the remaining water has flown out of
the spout. Then move the spout outwards and
immerse it into the fluid to heat.
32
Slowly open the steam/hot water knob and
heat the fluid using a circular movement from the
bottom to the top.
When the fluid has reached the desired tem-
perature, close the knob and immediately clean
the spout with a damp cloth.
Warning: the spout is hot, it may cause burns!
If you are not going to use the steam/hot water
dispensing tube any longer, position it over the
cup holder grill and disactivate the steam func-
tion by pressing the key .
"OVERTEMPERATURE
The machine stops working and does not brew
coffee. Let it cool down or open the steam/hot
water knob again.

INCORPORATED SAFETY DEVICES

"HOT WATER
"OVERTEMPERATURE
Drain the machine (the pump starts automati-
cally) until water flows regularly out of the spout
(see section on Drainage, page. 15) and the
display shows
"HOT WATER
"
Close the steam/hot water knob. The machine
is ready to brew coffee again.
Cappuccino froth
Fill a cup 1/3 with cold fresh milk, then immerse
"
the steam/hot water dispensing tube (7) just below
"
the milk surface. Move the cup with a circular
movement to form a thick froth. Then immerse the
dispensing tube deep into the milk to heat it.
USER MAINTENANCE
INSTRUCTIONS
Incorporated safety devices
Automatic off
Should the service door be open, the machine
automatically switches off and its operation is thus
prevented. If the central unit is not mounted, it is
possible to dispense water but not steam and coffee.
Electronic grinding time control
As soon as the coffee bean container is empty, the
machine automatically stops after approx. 20
seconds. Fill the container with coffee beans. The
coffee brewing cycle can be restarted.
"
Electronic pump delivery control
The machine switches off automatically as soon
as the water tank is empty.
"
"
"