Troubleshooting - Saeco Royal SUP 016 User's And Maintenance Booklet

87
Trouble
No message is displayed
The automatic coffee brewing does
not start .
The automatic coffee brewing
Water is dispensed instead of
coffee
Steam and hot water are not
dispensed
Coffee is dispensed too quickly
Coffee is dispensed too slowly
Coffee is not hot enough
Coffee is not creamy enough
The machine coffee brewing is re-
duced, it takes longer to heat and
the dispensing is not sufficient
The central unit cannot be re
moved
Possible causes
The machine is not getting power
The service door is open
BREW UNIT MISS.
BREW UNIT BLOCK
WATERTANK EMPTY
COF. BEANS EMPTY
DREGDRAWER MISS
GRINDER BLOCKED
Pre-ground coffee selection
button has been pressed, but the
relevant container is empty
The steam/hot water spout hole is
clogged
Grinding too coarse
Grinding too fine
The central unit filter is clogged
The cup has not been preheated
The temperature warning light is
not yet on
The coffee blend is not suitable
or is not fresh. Grinding is not
correct (too fine or too coarse]
Descaling the machine
The central unit has not been
correctly positioned

TROUBLESHOOTING

Solution
Turn the main switch on, check
plug and fuse
Close the service door
Properly fit and lock the central
unit
Clean the central unit (see page
83)
Fill with water or coffee beans and
restart the cycle
Fit the coffee grounds containei
properly
Service the coffee grinder (see
page 84)
Fill one measuring spoon of pre-
ground coffee
Clear the hole with the aid of a
thin needle
Adjust the grinder on a finer
grinding, e.g. from 5 to 3
Adjust the grinder on a coarser
grinding, e.g. from 5 to 7
Clean the filter
Heat the cup on the heating plate
Wait the "Ready to be used'
message
Try another coffee blend
Descale the machine, as de
scribed at page 84
Switch the machine on, close
the service door, fit the coffee
grounds container and wait until
the machine resets.