Unpacking/Installation; Power Supply Connection - Saeco Royal SUP 016 User's And Maintenance Booklet

73

Unpacking/installation

Standard packing is strong enough to protect the
machine during mail shipping. Keep this package
to return the machine to the manufacturer,
whenever necessary.
Before installing the machine, keep to the follow-
ing safety indications:
Whenever possible, use the machine with swivel
(24). When installing the machine, make sure the
swivel is always fitted in the provided area on the
lower side of the machine.

Power supply connection

Warning: electric current may cause
death! Always keep to safety rules.
The coffee machine must be connected to an
adequate socket. Voltage must suit to the voltage
specified on the appliance rating plate.
Never use defective power cords!
Defective power cords and plugs must be replaced
by an authorized
personnel.
Should an extension cord be used,
check ifs perfect conditions. The ex-
tension cord must have a minimum
section of 1 mm' and must be supplied with a
three-pole plug/socket.
INSTALLATION
Parts under current shall never be in contact
with water: danger of short-circuit! Overheated
steam and hot water may cause burns. Do not
direct steam or water jet towards the body;
furthermore, great attention must be given
when touching either the steam/ hot water
spout or the heating plate:
danger of burns!
Never use the machine without water
or coffee beans.
Remove measuring spoon, brush and the central
unit key from the coffee grounds container (1) and
keep them within reach.
Unwind the power cord (5) from the rear side of
the machine.
30 Remove the cover (1 5) and fill the container
with coffee beans (300 g approx.), then, replace
the cover. Adjust grinding by means of the grind
adjustment lever (17), positioning it on point "5" of
the scale.
Never fill the coffee bean container with
other products since they might
damage the machine!
Before filling the container with coffee
beans, make sure the pre-ground cof-
fee container (14) is closed to prevent coffee
beans from falling into it. They might damage the
machine!
Remove water tank (11) from the machine,
remove its cover (1 2) and fill it with cold water
(approx. 2.41). A valve on the tank bottom
prevents water from escaping.