Arm Assembly - Weider WESY39311 User Manual

9. Attach the upper ends of the Short Weight Guides
(73) to the Top Frame (55) with a 5/16" x 6" Bolt
(60), two 1/2" x 3/4" Spacers (61), and a 5/16"
Nylon Locknut (3).
Attach the upper ends of the Long Weight Guides
(62) to the Top Frame (55) with a 5/16" x 6" Bolt
(60), two 1/2" x 3/4" Spacers (61), and a 5/16"
Nylon Locknut (3).

ARM ASSEMBLY

10. Locate and open the parts bag labeled "ARM
ASSEMBLY."
Be sure there is a Bushing (98) in each side of the
Stabilizer (5). Press a 2" Square Inner Cap (27) into
each end of the Leg Press Arm (96).
Lubricate a 3/8" x 3 1/4" Bolt (67). Attach the Leg
Press Arm (96) to the Stabilizer (5) with the Bolt and
a 3/8" Nylon Locknut (21). Do not over tighten the
Nylon Locknut; the Leg Press Arm must be able
to pivot freely.
Align the welded tubes on the Leg Press Plate (95)
with one set of holes in the Leg Press Arm (96).
Attach the Leg Press Plate to the Leg Press Arm
with the Press Pin (97).
11. Press a 1" x 7/8" Plastic Bushing (90) onto each
welded spacer on the Press Frame (17). Slide the
Press Frame into place onto the Base (4). Note:
This will be a tight fit. The Plastic Bushings
should fit on each end of the indicated tube in
the Base. Make sure that the indicated holes are
on the side shown.
Lubricate the 3/8" x 8" Bolt (59). Attach the Press
Frame (17) to the Base (4) with the Bolt and a 3/8"
Nylon Locknut (21).
9
61
60
73
10
96
5
11
21
4
Tube
9
61
3
3
55
60
62
27
95
Welded
Tube
21
27
Lubricate
67
27
98
Holes must
17
be on
this side
Lubricate
59
Welded Spacers
90
97