Weider WESY39311 User Manual page 16

32. Wrap the Military Press Cable (72) around a 3 1/2"
Pulley (15). Attach the Pulley and a Cable Trap (66)
to the Pivot Arm (80) with the 3/8" x 5" Bolt (101).
Be sure the Bolt is on the side shown, and that
the Cable Trap is positioned to hold the Cable in
place. Do not attach a locknut yet.
See the inset drawing. Wrap the Military Press
Cable (72) around a 3 1/2" Pulley (15). Attach the
Pulley and a Cable Trap (66) to the upper hole in
the Long "U"-Bracket (57) with a 3/8" x 2" Bolt (12)
and a 3/8" Nylon Locknut (21). Be sure that the
Cable Trap is inside the Long "U"-Bracket, that
the Cable is in the groove of the Pulley, and that
the Cable and Pulley move smoothly.
Wrap the Military Press Cable (72) around another
3 1/2" Pulley (15). Attach the Pulley and a Cable
Trap (66) to the 3/8" x 5" Bolt (101) on the other
side of the Pivot Arm (80) with a 3/8" Nylon Locknut
(21). Be sure that the Cable Trap is positioned to
hold the Cable in place, and that the Cable is
routed as shown.
33. Wrap the Military Press Cable (72) around a 3 1/2"
Pulley (15). Attach the Pulley and a Cable Trap (66)
to the Leg Press Upright (56) with a 3/8" x 2" Bolt
(12) and a 3/8" Nylon Locknut (21). Be sure the
Cable Trap is positioned to hold the Cable in
place.
34. Lay the Military Press Cable (72) over a 3 1/2"
Pulley (15). Attach the Pulley and both Pulley
Covers (77) to the Leg Press Upright (56) with a
3/8" x 3 3/4" Bolt (88), two 3/8" Washers (9), and a
3/8" Nylon Jamnut (99).
Make sure that the Military Press Cable (72) is
between the 3 1/2" Pulley (15) and the post. Be
sure that the Cable and Pulley move smoothly.
The Pulley Covers (77) must be turned so that
the large tabs face toward the weight system.
See the inset drawing.
32
15
101
66
72
33
21
34
99
9
77
56
16
80
66
21
57
15
21
57
56
72
66
15
72
Post
15
Large tabs
must be in
9
this location
88
66
12
12