Weider WEBE4496.0 User Manual page 20

38. Wrap the Cable (131) over a Small Pulley (59).
Attach the Small Pulley and a Cable Trap (76) to
the inside of the Rear Frame (31) with an M10 x
45mm Bolt (104) and an M10 Nylon Locknut (94).
39. Remove the M4 x 12mm Self-tapping Screw
(123) and the Swivel Arm (48) from the Left Front
Frame (32). Route the Cable (131) through the
slot in the Left Front Frame and through the
Swivel Arm. Make sure the Cable is routed
under the bar in the Swivel Arm.
Attach the Swivel Arm (48) to the Left Front
Frame (32) with the M4 x 12mm Self-tapping
Screw (123).
Position the Bottom Plate (65) and the Top Plate
(64) around the Cable (131) as shown. Attach the
Bottom and Top Plates to the Left Front Frame
(32) with two M4 x 16mm Self-tapping Screws
(102).
40. Attach a Small Pulley (59), two 16mm x 6mm
Spacers (91), an Outer Pulley Cover (63), and an
Inner Pulley Cover (82) to the Swivel Arm (48)
with an M10 x 60mm Bolt (117), two M10
Washers (96), and an M10 Nylon Locknut (94).
Make sure the Spacers are inside the Swivel
Arm.
38
39
102
The Cable
must pass
on this side
123
of the Bolt.
48
Bar 32
131
40
94
96
48
63
91
131
20
59
76
104
131
94
31
64
65
96
59
82 117
91