Weider WEBE4496.0 User Manual page 13

17. Attach the Center Upright (29) to the Rear Base
(25) with the two M10 x 70mm Bolts (116) and
two M10 Nylon Locknuts (94). Do not tighten
the Nylon Locknuts yet.
18. Identify the Rubber Carriage Stop (133) and the
Metal Carriage Stop (132). Then, slide the
Rubber Carriage Stop onto the Rear Upright (30).
Attach the Rubber Carriage Stop (133) to the
Rear Upright (30) with an M10 x 81mm Bolt
(100), two M10 Washers (96), and an M10 Nylon
Locknut (94).
See the inset drawing. Orient the Weight Carriage
(55) with the notch at the top as shown, and then
slide the Weight Carriage onto the Rear Upright
(30). Next, slide a Carriage Bumper (85) and the
Metal Carriage Stop (132) onto the Rear Upright.
Attach the Metal Carriage Stop (132) to the Rear
Upright (30) with an M10 x 75mm Bolt (125), two
M10 Washers (96), and an M10 Nylon Locknut
(94).
Attach the Rear Upright (30) to the Rear Base
(25) with an M10 x 65mm Bolt (124), two M10
Washers (96), and an M10 Nylon Locknut (94).
Do not tighten the Nylon Locknuts yet.
17
18
94
94
124
13
29
94
94
25
116
133
96
96
100
30
55
85
96
96
125
94
132
25
55
Notch