Weider WEBE4496.0 User Manual page 10

9. Insert a Pad Tube (12) into the lower hole in the
Leg Lever (5). Slide two Small Pads (13) onto the
Pad Tube. Press a Pad Cap (14) into each end of
the Pad Tube.
Repeat this step with the other Pad Tubes (12)
and the Front Leg (4).
10. Attach the Curl Pad (11) to the Curl Post (8) with
two M6 x 16mm Screws (105).
11. Orient a Front Base (26) as shown. Insert four
M10 x 81mm Bolts (100) and four M10 Washers
(96) up through the Front Base. Place tape over
the Bolt heads to hold them in place.
Repeat this step for the other Front Base (26).
9
14
12
13
10
11
11
10
12
4
5
12
13
105
8
26
26
96
100
96
100
14