Seat Assembly - Weider Pro 2250 User Manual

19. Note: The 3 1/2" Pulley (15) in this step has
been preassembled. It is shown exploded in
this drawing for clarity.
Route the Long Cable (23) over a 3 1/2" Pulley
(15). Make sure that the Cable Trap (66) is ori-
ented to hold the Cable in the groove of the
Pulley. Tighten the 3/8" x 2" Bolt (12) and the 3/8"
Nylon Locknut (21).
20. Attach the Long Cable (23) to the Small "U"-
bracket (67) with a 1/4" Nylon Locknut (2) and a
1/4" Washer (10). See the inset drawing. Do not
overtighten the Locknut; it should be threaded
onto the end of the Cable so that two threads
are showing past the nut.
Attach the Small "U"-bracket (67) to the Weight
Tube (63) with a 5/16" x 1 3/4" Bolt (72) and a
5/16" Nylon Locknut (3).

Seat Assembly

21. Attach the Backrest (41) to the Front Upright (42)
with two 1/4" x 2 1/2" Screws (43) and two 1/4"
Washers (10).
19
20
23
67
72
63
21
11
55
21
Bracket
15
12
23
23
3
10
2
41
43
10
42
43
10
2
67