Weider 8510 User Manual page 8

8. Press a 1 3/4Ó Square Inner Cap (44) into the
top of a Press Arm (46). Press a 1Ó Round
Inner Cap (49) into each end of the handle on
the Press Arm. Attach the Press Arm to one
side of the Press Frame (17) with two 5/16Ó x
2 1/2Ó Bolts (22) and two 5/16Ó Nylon
Locknuts (3).
Assemble the other Press Arm (46) in the
same manner.
9. Identify the Right Arm (48) and the Left Arm
(47). Note the position of the welded bracket
on each Arm. Arm identification is very
important for step 10.
Note: The ÒVÓ-Pulleys (6), Long Cable Traps
(50), 3/8Ó x 2 1/2Ó Bolts (7), and 3/8Ó Nylon
Locknuts (21) are pre-attached. These have
been shown disassembled for easy part iden-
tification.
10. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right
Arm with the Left Arm (47); refer to step 9
to identify the Right Arm. Be sure that the
upper end of the Right Arm is behind the
indicated bracket on the Top Frame (55).
Tap two 1Ó Retainers (69) and a 1Ó Round
Cover Cap (70) onto the right axle. Be sure
that the teeth on the Retainers bend
toward the Cover Cap, as shown in the
inset drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4Ó Square Inner Caps (44) into the
lower ends of the Right and Left Arms (47,
48). Wet the lower end of each Arm with
soapy water. Slide a 10Ó Pad (45) onto the
lower end of each Arm.
8
44
49
46
9
50
6
Welded
Brackets
48
10
48
44
45
8
44
49
49
46
22
3
17
50
7
6
47
21
55
47
Bracket
Lubricate Axle
69
70
45
55
69
70