Advertisement
36. Grease an M8 x 22mm Shoulder Bolt (39). Attach
the Butterfly Cable (106) to the Right Butterfly
Arm (7) with the Bolt and an M8 Nylon Locknut
(91). Make sure the fiat edge of the Cable is
against the Butterfly
Arm.
37. Locate the Short Cable (108). Attach the Cable
to the M8 x 96mm Bolt (83) used in step 6 with
an M8 Washer (98), an M8 x 13mm Spacer (103),
and an M8 Nylon Locknut (91).
38. Wrap the Short Cable (108) over a 90mm Pulley
(63). Attach the Pulley and two Half Finger
Guards (66) to the Double "U'-bracket (61) with
an MIO x 48mm Bolt (84) and an MIO Nylon
Locknut (90). Make sure the Finger Guards are
oriented
as shown.
39. Attach the end of the Short Cable (108) to a "U'-
bracket (50) with an M8 Washer (98) and an M8
Nylon Locknut (91). Note: Do not completely
tighten the Locknut;
it should
be tightened
so
that only two threads of the Cable show past
the Locknut,
as shown in the inset drawing.
40. Locate the Weight Cable (110). Route the Cable
up through the Right Top Frame (5) and over a
90mm Pulley (63). Attach the Pulley inside the
Top Frame with an MIO x 80mm Bolt (75), two
MIO Washers (99), two MIO x 19mm Spacers
(102), and an MIO Nylon Locknut (90).
36
37
38
39
4O
39
G rease_4 _
106_
103
83
66
84
91
O8
50
110
16
Advertisement
