Table of Contents
Advertisement
4. If you want to continue setting, press Enter. Otherwise, press Clear to cancel
the set process.
See "Inhibiting / uninhibiting zones" on page 19 for more information.
If programmed, the exit tone sounds. This may be a continuous tone or an
intermittent tone.
The exit tone switches off.
When an area is partially set, its LED lights up red.
If programmed, after a delay the armed display is engaged, and LEDs are
extinguished.
Unset areas via LCD keypad
To unset areas via LCD keypad:
1. Enter the premises using the designated entry/exit route.
An intermittent entry tone starts and the following prompt is displayed:
Enter card/code
to unset
2. Provide an allowed key sequence indicated in "Common key sequences" on
page 28.
3. If prompted, choose areas. See "Areas displayed during set and unset" on
page 12 for more information.
The entry buzzer stops and the areas are unset.
LEDs are extinguished, and the time and date is displayed.
Set areas via keypad without LCD
To set areas via keypad without LCD:
1. Provide an allowed key sequence indicated in "Common key sequences" on
page 28.
If the operation is not possible, the keypad beeps seven times. See "When
you cannot set or unset" on page 8 for more information.
The exit tone sounds. This may be a continuous tone or an intermittent tone.
2. Exit the premises using the designated entry/exit route.
The exit tone switches off.
When an area is set, its LED lights up red.
If programmed, after a delay the armed display is engaged, and LEDs are
extinguished.
Advisor Advanced ATSx500A User Guide
11
Hide quick links:
Advertisement
Table of Contents
