Assembly - Weider 831.150280 User Manual

Assembly

Before beginning assembly, carefully read the
following information and instructions:
• Place all parts of the WEIDER
area and remove the packing materials; do not
dispose of the packing materials until assembly
is completed.
• Read each assembly step before you begin.
• For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART on the previous page. Note: Some
small parts may have been pre-attached for ship-
ping purposes. If a part is not in the parts bag,
check to see if it has been pre-attached.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
1. Before assembling this product, be sure that
you have read and understand the information
in the box above.
Tap two 38mm Square Inner Caps (21) into each
Upright (1).
Attach the Crossbar (3) to each Upright (1) with
four M8 x 57mm Bolts (14), four M8 Washers
(12), and four M8 Nylon Locknuts (13). Be sure
that the Crossbar (3) and Uprights (1) are ori-
ented as shown. The decal must be facing up
and the high side of the weight rests must both
be on the same side.
2. Tap two 30mm Square Inner Caps (22) into the
Front Leg (8).
Attach the Front Leg (8) to the Frame (2) with the
M10 x 19mm Bolt (17).
• As you assemble the WEIDER
® 128 in a cleared
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) phillips screwdriver
• One (1) rubber mallet
• Lubricant, such as grease or petroleum jelly,
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
6
that all parts are oriented as shown in the draw-
ings.
and soapy water will also be needed.
1
1
12
13
14
12
13
21
2
2
17
22 8
22
® 128, make sure
High Side of
Weight Rests
1
3 13
12
14
13
12
21