Husqvarna 455 Rancher II Workshop Manual page 43

Fitting on the saw
1
Press the connector together as outlined in
figure 44 and press it into place in the holder.
2
Connect the cables to the stop switch.
See figure 45.
3
Fit the carburetor and make sure the lug on the
carburetor hooks in place on its mounting on the
intake system. See figure 46.
Make sure that the following components are
correctly fitted:
• Position the air filter holder against the
carburetor.
• Make sure the carburetor cover's intake channel
is aligned correctly with the slot for the air filter
holder.
• The spring must be fitted under the choke pin on
the carburetor. See figure 47.
• The rubber collar on the stop button must be
on the inside of the bottom of the carburetor
compartment. See figure 47.
NOTE! Make sure that the fuel and return hoses
are not crushed.
Fig 44
Fig 45
Fig 46
Fig 47
Repair Instructions
43
English –