Crossover Ignition System Operations; General Maintenance - Weber SUMMIT 650 Operating Manual

GENERAL MAINTENANCE

11. Lift and twist the burner assembly slightly to separate
the crossover tube(1) from the burners. Remove the
burners from the cooking box.
Separate here
12. To reinstall the burners, reverse steps 3 through 11.
CAUTION: The burner openings must be positioned
properly over the valve orifices. Figure 15 (a).
Check proper assembly before fastening manifold in
place. Figure 15 (b).
(a)
Valve
Burner
Orifice
(b)
Figure 15
Crossover
If the Crossover Ignition System fails to ignite the Left
burner, light the Left burner with a match. If the Left
burner lights with a match, then check the Crossover
Ignition System.
• Check that both the white(1) and black(2) ignition wires
(1)
• Check that the Crossover Ignition button pushes the
• Check to see if the igniter is loose in the frame.
If the Crossover Ignition System still fails to light, Contact
the Customer Service Representative in your region using
the contact information sheet provided with your manual.
16
® Ignition System Operations
are attached properly.
(1)
igniter (button) down, and returns to the up position.
Tighten if necessary; See Step "Install igniter" for
correct procedure.
(2)