Crossover Ignition System Operations - Weber SUMMITT M425 Operating Manual

MAINTENANCE
12. Lift and twist the burner assembly slightly to separate
the crossover tube from the burners. Remove the
burners from the cooking box. Figure 15.
13. To reinstall the burners, reverse steps 3 through 12.
CAUTION: The burner openings must be positioned
properly over the valve orifices. Figure 16 (a).
Check proper assembly before fastening manifold in
place. Figure 16 (b).
(a)
Valve
Burner
Orifice
(b)
Separate here
Crossover tube
Figure 15
Figure 16
14. Reinstall the Spider Stopper Guards. Slightly rotate
the Spider Stopper Guards so that the seams are in
line with the Venturi fins. There should be no gaps in
the seams or in the fit around the burners and valves.
Figure 17.
Venturi fin

Crossover Ignition System Operations

If the Crossover Ignition System fails to ignite the Left
burner, light the Left burner with a match. If the Left
burner lights with a match, then check the Crossover
Ignition System.
Check that both the white and black ignition wires are
attached properly. Figure 18.
Check that the Crossover Ignition button pushes the
igniter (button) down, and returns to the up position.
Check to see if the igniter is loose in the frame.
Tighten if necessary; See Step "Install igniter" for
correct procedure.
If the Crossover Ignition System still fails to light, contact
Weber-Stephen Customer Service.
White wire
Black wire
13
Check fit
around valve
Check fit around burner
Figure 17
Figure 18