Cable Assembly - Master HERMES User Manual

EN

CABLE ASSEMBLY

1. Connect the cable with no ball (11)
Connect one end of the cable to up right chest support (J) with bolt M10*20+lock nut (22). Tack the other
end of the cable up and round pulley 1, under and round pulley 3, up and round pulley 2, then connect the
end to up left chest support (K) with bolt M10*20+lock nut (22).
2. Connect the cable with one and a half ball (12)
Note: In this step, you should take out the pulleys from their position.
Take the end with half ball of the cable up pulley 4, up and round pulley 5, under and round pulley 6, up and
round pulley 14.
3. Connect the cable with one ball (13)
Take the end with no ball of the cable under pulley 8、9、10, up and round pulley 11, under and round
pulley 12, up and round pulley 13, under and round pulley 15, up and round pulley 7, down and secure cable
to selector shaft (Y) with chain (6) and hooks (7).