Intercharacter Delay - Wasp WLP 4170 CCD Programming Manual

Wasp ccd scanner programming guide

Table of Contents

Setup & Configuration

—Intercharacter Delay

The 'Intercharacter Delay' configuration sets the speed at which the WLP 4170

CCD Scanner sends data. The intercharacter delay should be changed only if

the transfer rate cannot be maintained between WLP 4170 CCD Scanner and

the keyboard buffer of the computer.

Note: The default for the intercharacter delay is set to '2ms' and is the most

common configuration; however, your PC may be different.When you scan a bar

code, if some characters are missing, decrease the intercharacter delay speed

to speed up the transfer rate. If some stray or scrambled characters appear on

your screen, increase the intercharacter delay to slow down the transfer rate.

NOTE: For help in configuring these settings, consult the programming

steps on page 5.

Begin

Set Intercharacter

Delay

Exit

Intercharacter Delay Settings

Slowest

Slow

Default

Medium

Fast

Fastest

Table of Contents