WAGNER Model 9140 Owner's Manual page 8

P
RACTICE
CAUTION
Be sure that the paint hose is free of kinks and clear of
objects with sharp cutting edges.
1. Switch the pump ON (l)
and turn the
PRIME/SPRAY knob to
SPRAY.
2. Turn the pressure contol
dial to its highest setting
(+). The spray hose
should stiffen as paint
begins to flow through it.
3. When the motor shuts off, unlock the spray gun and spray
a test area to check the spray pattern.
When enough pressure has built up in the hose, the
motor will shut off automatically. The motor will cycle
on and off automatically as it needs pressure.
The pressure control
dial can be adjusted up
or down to achieve the
desired spray pattern.
S T
PRAYING ECHNIQUE
The key to a good paint job is an even coating over the entire
surface. This is done by using even strokes. Follow the TIPS,
below.
TIP: Keep your arm moving at a constant speed and
keep the spray gun at a constant distance from
the surface. The best spraying distance is 10 to
12 inches between the spray tip and the surface.
Even coat throughout
Keep stroke smooth and at an even speed.
English
S
PRAYING
PRIME
SPRAY
Good spray pattern
Paint tailing pattern
Approximately
10 to 12 inches
Customer Service: 800-880-0993
TIP: Keep the spray gun perpendicular to the
surface, otherwise one end of the pattern will
be thicker than the other.
Approximately
10 to 12 inches
Right way
Wrong way
TIP: Keep the spray gun at right angles to the
surface. This means moving your entire arm
back and forth rather than just flexing your wrist.
Light Coat Heavy Coat
Do not flex wrist while spraying.
TIP: The spray gun should be triggered by turning it
on and off with each stroke. Do not trigger the
gun during the middle of a stroke. This will result
in an uneven spray and splotchy coverage.
Proper way to trigger the spray gun
Keep stroke
even
Start stroke Pull trigger Keep steady
ADDITIONAL TIPS
Overlap each stroke by about 30%. This will ensure an
even coating.
When you stop painting, follow PRESSURE RELIEF
PROCEDURE.
IF YOU EXPECT TO BE AWAY FROM YOUR SPRAYER
FOR MORE THAN ONE HOUR, FOLLOW THE SHORT-
TERM CLEANUP PROCEDURE DESCRIBED IN THE
STORAGE SECTION OF THIS MANUAL (page 12).
8 © 2003 Wagner Spray Tech - All rights reserved.
Light Coat
Approximately
10 to 12 inches
Release trigger End stroke