WAGNER Model 9140 Owner's Manual page 4

C
C
OMPONENTS
The shipping carton for your painting system contains the following:
• Suction set and return tube
• Spray gun with filter
• Spray tip assembly (see chart below)
• 25 foot long, 1/4 inch diameter pressure hose (9140, 9140S, 9150)
• 50 foot long, 1/4 inch diameter pressure hose (9170, 9190, 9210)
• Separating Oil
C F
ONTROLS AND UNCTIONS
ON/OFF Switch ................The ON/OFF switch turns the unit on
and off (O=OFF, l=ON).
Suction Set .......................Fluid is drawn through the suction
set into the pump.
Fluid Section ....................A piston in the fluid section moves up
and down to create the suction that
draws fluid through the suction set.
Spray Gun ........................The spray gun controls the delivery
of the fluid being pumped. The gun
model you have depends on your
Spray Gun/Tip Chart
Sprayer Gun Tip
Model Model Size
9140/S GX-06 .013
9150 GX-07 .013
9170 GX-07 .015
9190 GX-08 .017
9210 GX-10 .017
Hose
bracket
Handle
Motor
housing
Lubricating
area (on front
face plate)
Pail bracket
Spray hose
Spray
tip
Spray
gun
English
OMPONENTS AND
Max. Recommended
Size Filter
.015 Yellow (fine)
.015 Yellow (fine)
.017 Yellow (fine)
.019 White (medium)
.021 White (medium)
Return
tube
Suction
tube
Customer Service: 800-880-0993
D
ESCRIPTION
sprayer model (refer to Spray
Gun/Tip Chart, below).
Spray Hose ......................The spray hose connects the gun to
the pump.
Return Tube......................Fluid is sent back out through the
return tube to the original container.
PRIME/SPRAY Knob........The PRIME/SPRAY knob directs fluid
to the spray hose when set to SPRAY
or the return tube when set to PRIME.
The arrows on the PRIME/SPRAY
knob shows the rotation directions for
PRIME and SPRAY.
The PRIME/SPRAY knob is also used
to relieve pressure built up in the
spray hose (Pressure Relief
Procedure, page 6)
Pressure Control Dial .......The pressure control dial controls
the amount of force the pump uses
to push the fluid (see graphic below
for locations).
Rear of motor shroud,
(9140, 9140S, 9150,
9170, and 9190).
PRIME position
ON/OFF switch
O = OFF
l = ON
PRIME/
SPRAY
knob
Fluid
section
Suction set screen
4 © 2003 Wagner Spray Tech - All rights reserved.
Pressure Control Dial
Front face plate,
9210 model
Spray hose
port
Pressure Control Dial
PRIME/SPRAY knob
SPRAY position
PRIME
SPRAY
O