Cleaning; Daily Cleaning; Complete Cleaning - Vulcan-Hart VCG10H ML-126836, VCG10F ML-126837, VCG20H ML-126838 Installation And Operation Manual

Gas combi convection & steam ovens

Hide thumbs Also See for VCG10H ML-126836, VCG10F ML-126837, VCG20H ML-126838:

Table of Contents

CLEANING

Preheat the oven to 130 F and spray a mild detergent solution that does not contain chlorine on the

inside surfaces of the oven. A Spray Bottle is provided. Allow the detergent solution to react for

15 minutes.

Operate the oven on Steam mode for 15 minutes. Allow the oven to cool; wipe the oven interior with

a sponge and warm water. Dry the oven interior with a clean soft cloth.

DO NOT use abrasive products.

Clean the exterior with a cloth or sponge and non-agressive, non-abrasive products.

WARNING: UNPLUG THE ELECTRICAL POWER CORD.

Remove the Rack (Fig. 8). Remove the Grease Filter (Fig. 8) at the rear of the oven chamber by lifting

up and out. Remove the Fan Baffle (Fig. 9) by lifting up and out. Remove the Rack Retainer (Fig. 9)

normally located under the Grease Filter and Fan Baffle. Wash the removed parts in a sink with warm

soapy water, rinse with clear water and dry with a clean dry cloth.

Clean all areas of the oven and all parts. Reinstall the parts in their original positions.

If using the hose spray accessory to clean the oven interior, DISCONNECT ELECTRICAL POWER

and avoid spraying near the controls.

DO NOT use steel wool or abrasive scouring pads as they will scratch and ruin the oven surfaces.

Sanitize the temperature probe. Return it to its home position in the bracket on the ceiling of the oven.

DO NOT spray cleaners, detergents or water directly onto the burner. This may cause mechanical

problems.

Rack

Grease Filter

Fig. 8

PL-40542-1

– 32 –

Fan Baffle

Rack Retainer

PL-41364-1

Fig. 9

Table of Contents