Table of Contents
Advertisement
3VE490040NU – 01/20
- Select the required level of cleaning depending on how dirty the oven is.
- Check the pipes are connected to the chemical containers and that the quantities are sufficient. If not refer to the paragraph
"Replacing the chemical containers"
- Press to select:
- Press to select:
- The screen indicates the different phases selected for the cycle, the running time and remaining time. When the cleaning cycle has
finished the Service screen is displayed again.
7.2
"AUTO" CLEANING (cleaning programmed every day of the week):
- Switch the oven on.
- Wait until the start up screen disappears. If preheating starts press STOP.
- Select the Service screen.
- Press to select:
- Put in your PIN code (0000 by default, select Client parameters in the service screen) then validate.
- The daily cleaning screen will appear.
- For each day select the level of clean required and the time by pressing the corresponding touch button then validate
- The automatic cleaning programme is displayed. The cleaning cycle will start at the set hour each day and at the intensity selected
- To deactivate the automatic cleaning select Manual cleaning enter your PIN. The values programmed in will be remembered for the
next time you select automatic cleaning.
- Please note: If a cooking cycle is running at the time an automatic wash should start the cleaning cycle will be cancelled.
7.3
RAPID RINSING
Page 12
"Cleaning level" Light, medium or intensive.
The time for each is indicated on the left.
"Back".
"Start" a cleaning cycle.
"Auto cleaning"
"Programming screen".
"Manual cleaning"
Rapid rinse function using only water (no chemical) for example between
two different types of cooking
VULCAN
A division of ITW Food Equipment Group LLC
P.O. Box 696
Louisville, KY 40201
EN
Advertisement
Table of Contents
