Page 1
INSTALLATION & OPERATION MANUAL 7000 SERIES GAS OVENS MODEL 7018A1 ML-104491 7088A1 ML-104492 7888A1 ML-104493 7086A1 ML-104494 7016A1 ML-104495 7066A1 ML-104496 7019A1 ML-104497 7099A1 ML-104498 7999A1 ML-104499 7096A1 ML-104500 7098A1 ML-104501 7988A1 ML-104502 7998A1 ML-104503 MODEL 7019A1 V U L C A N - H A R T C O M P A N Y , P . O . B O X 6 9 6 , L O U I S V I L L E , K Y 4 0 2 0 1 - 0 6 9 6 , TEL. (502) 7 7 8 - 2 7 9 1 FORM 30857 (Rev.
Page 2
IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. POST IN A PROMINENT LOCATION THE INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE SMELL OF GAS IS DETECTED.
MODEL 7000 SERIES ROAST OVEN CONFIGURATIONS 7019A1 7099A1 Model 7999A1 not shown. MODEL 7000 SERIES COMBINATION BAKE & ROAST OVEN CONFIGURATIONS 7096A1 7098A1 7988A1 Model 7998A1 not shown. — 5 — Get other manuals https://www.bkmanuals.com...
Proper installation, usage and maintenance of your oven will result in many years of satisfactory performance. All Model 7000 Series Bake and Roast Ovens are equipped with legs and adjustable feet. If desired, ovens may be mounted on a solid, noncombustible base in place of legs.
Before installing, verify that the type of gas supply (natural or propane) and electrical service (if applicable) agree with the specifications on the rating plate located on the control panel of the oven. If the supply and equipment requirements do not agree, contact your dealer or Vulcan-Hart immediately. LOCATION The equipment area must be kept free and clear of combustible substances.
Stacking Model 7016A1, 7018A1 and 7019A1 Ovens The Vulcan 7000 Series Oven is offered in three different configurations: • Bake Oven 7016A1 and 7018A1.
These ovens can be mounted interchangeably starting with the largest section on the bottom. The factory shipping tags will be marked accordingly. For the purpose of stacking positions, the suffix letter at the end of the model number is your guide: T —...
GAS CONNECTIONS All gas supply connections and any pipe joint compound used must be resistant to the action of propane gases. The oven is equipped for a " gas pipe connection. Pipe gas supply to the oven. Make sure the pipes are clean and free of obstructions, dirt and piping compound.
ELECTRICAL CONNECTIONS WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES. WARNING: APPLIANCES EQUIPPED WITH A FLEXIBLE ELECTRIC SUPPLY CORD ARE PROVIDED WITH A THREE-PRONG GROUNDING PLUG. IT IS IMPERATIVE THAT THIS PLUG BE CONNECTED INTO A PROPERLY GROUNDED THREE-PRONG RECEPTACLE.
OPERATION WARNING: THE OVEN AND ITS PARTS ARE HOT. USE CARE WHEN OPERATING, CLEANING OR SERVICING THE OVEN. CONTROLS (Fig. 4) Burner Valve — when opened, allows gas to flow to the oven burner. To open valve, turn knob counterclockwise; to close valve, turn knob clockwise. Ignition Button —...
LIGHTING AND SHUTTING DOWN PILOT 1. Turn on main gas supply. 2. Turn burner valve ON and purge air from line. Turn burner valve OFF. 3. Wait 5 minutes, then turn burner valve ON and depress ignition button. Using a lit taper, ignite oven pilot (Fig.
PREHEATING Set thermostat knob to desired temperature and allow oven to preheat for approximately 15 minutes before loading. LOADING OVEN 1. When using 2- or 4-deck sections that have one control for two compartments, load both compartments simultaneously. If a quantity sufficient for only one compartment is to be baked, load only the compartment with the thermostat bulb.
CLEANING WARNING: TURN OVEN OFF AND UNPLUG THE ELECTRICAL CORD (IF APPLICABLE) BEFORE CLEANING. Clean interior and exterior of oven daily with warm water and detergent solution. Rinse thoroughly and wipe dry with a soft clean cloth. Oven Inspection Window (Optional) The oven inspection window may be cleaned with an oven cleaner compound or with a cloth dampened with detergent solution.
Make sure the pilot is lit. Service and Parts Information To obtain service and parts information concerning your 7000 Series Bake/Roast Oven, contact the Vulcan-Hart Service Depot in your area (refer to listing supplied with the oven), or Vulcan-Hart Company Service Department at the address or phone number shown on the front cover of this manual.