Cleaning Menu - Vulcan-Hart TCM Series Operating Manual

3V-490058NU – 12/21
There are 2 possibilities:
- Manual cleaning (on demand)
- Auto cleaning (cleaning programmed every day of the week):
24.1 « MANUAL » CLEANING (on demand):

2 possible mode choices :
- Washing with descaling activated as
default: if this choice is un-ticked the
cycle time is shortened to cleaning
time only,
- Descaling only: allows enhanced
descaling cycle to be run.
Procedure:
- Switch the oven on.
- Wait a few seconds until the start screen clears. If the preheat starts press STOP.
- Press the Service tab. The screen shows the last washing level used and whether a descaling cycle will be run.
- Press to select:
- The screen indicates the different phases selected for the cycle, the running time and remaining time. When the cleaning cycle has
finished the "Service" screen is displayed again.
Note: The washing level / descaling / dry can be modified:
- Press to select:
24
The cavity should never be cleaned with grills or
containers in situ.
Intensity of the cleaning: Light / Medium / Intensive / Ultimate (The durations are shown on
➔
the left)
Descaling included: In addition to the cleaning cycle, a descaling cycle will be run if
➔
necessary, depending on the use and setting of the oven. (Measured by the frequency of
use of the oven and the water hardness recorded in the parameters)
Integrated drying: drying of the cooking cham as well as the cleaning and/or descaling
➔
cycle if key is selected.
➔
"Cleaning and descaling (if necessary)"
➔
"Start" a cleaning cycle.
Page 13

CLEANING MENU

VULCAN
A division of ITW Food Equipment Group LLC
P.O. Box 696
Louisville, KY 40201
EN