Heating Elements - Vulcan-Hart VC4ED Service Manual

FULL SIZE ELECTRIC CONVECTION OVEN - REMOVAL AND REPLACEMENT OF PARTS
5. Remove probe by pushing it through the oven
wall and into the control panel area.
NOTE: The hole in the oven cavity wall does not
line up straight with the oven cavity outer shell,
therefore the probe must be removed at an angle.
6. Reverse the procedure to install the
replacement probe.
7. Adjust the temperature control as outlined
under "SOLID STATE TEMPERATURE
CONTROL CALIBRATION" in "SERVICE
PROCEDURES AND ADJUSTMENTS".

HEATING ELEMENTS

WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
NOTE: Starting with production in October, 2001,
the top cavity panel will have 3/4" square holes for
easier element removal. Ovens manufactured prior
to this date have 1/2" round holes that sometimes
make it difficult to remove elements thru the cavity.
A serial number cut off will not be available. Follow
the procedures for element removal as outlined
below.
Front Access
1. Remove the oven racks and rack supports.
2. Remove the "top" door seal from the oven.
3. Determine if the heating element to replace is
on the left or right side in the oven cavity. The
element locations from front to back are: Right
side - R1, R2 & R3; Left side - R4, R5 & R6.
A. Measure the current draw of the heating
elements as outlined under "HEATING
ELEMENT TEST" in "SERVICE
PROCEDURES AND ADJUSTMENTS".
4. From inside the oven cavity, remove the
perforated panel from the same side of the
element being replaced.
A. If removing the right side panel, also
remove the probe guard or mounting clips.
B. Run the probe wire thru the panel opening
before lifting panel out.
5. From the element being replaced, remove the
hold down clamps, the mounting bracket
screws at the top, then remove the element.
Page 9 of 60 F25105 (December 2001)