Before First Use - Vulcan-Hart SG4C ML-114876 Installation & Operation Manual

Sg series gas snorkel convection ovens
Hide thumbs Also See for SG4C ML-114876:
Table of Contents

Advertisement

Master Switch
On Light (Amber)
Heat Light (White)
No Ignition Light (Red)
Thermostat
Power Level Control
One-Hour Timer
Two-Speed Fan Switch
Light Switch

BEFORE FIRST USE

Before using the oven for the first time, it must be "burned in" to release any odors that might result from
heating the new surfaces in the chamber.
1. Using a clean damp cloth, wipe the inside of the oven, including the racks.
2. Close the oven doors, push the Master Switch to ON, turn the Thermostat to 300°F (149°C), and
allow the oven to cycle for 6 to 8 hours before pushing the Master Switch OFF.
— ON — turns oven control circuits on.
OFF — turns oven control circuits off.
OVEN COOL — allows the fan motor to run with the doors ajar to
speed oven cooling.
— Lit when Master Switch is positioned at ON.
— Comes on and goes off when the burner cycles on and off.
— Comes on if burner fails to ignite. When lighting the oven, the No
Ignition Light flashes.
— Controls oven temperature during cooking operation.
— A potentiometer which permits variation of the heat input between
22% and 100% of full input.
Dial Setting
10
9
8
7
6
5
4
3
2
1
— Use to set cooking cycle time. Alarm sounds continuously when
elapsed time counts down to 0; oven does not turn off. Turn timer
to OFF position to stop alarm. When oven is not in use, keep timer
at OFF position.
— Adjusts air velocity in the oven.
— Turns lights in the oven on or off.
— 13 —
Percent of Full Input
100%
77%
73%
68%
60%
53%
45%
37%
28%
22%

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sg4d ml-114875Sg6c ml-114878Sg6d ml-114877

Table of Contents