Heat & Glo 6000CLX-IFT-S Owner's Manual page 20

Brick Refractory, Grate and Valve Assembly
Removal
It may become necessary to remove the refractory, grate
and valve assemblies. This task should be performed by
a qualified service technician. The refractory, grate and
base refractory do not need to be removed to service the
burner assembly.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during remov-
al and installation. Sheet metal edges are sharp.
Note: Refractory is Fragile. Handle with care.
Figure 4.3 Side Refractory Removal
To remove the top refractory panel, lift the top refractory
panel up using both hands, slide it forward as much as
possible and carefully lower it.
To remove the side refractory panels, slide the panel
forward as shown in Figure 4.3. Rotate the panels and
remove as shown in Figure 4.4. Remove the back refrac-
tory panel by lifting it over the burner assembly.
NOTICE: Remove refractory before removing grate. If
grate is removed first, damage to refractory will occur.
20
Heat & Glo • 6000CLX-IFT, 8000CLX-IFT Owner's Manual • 2506-981 Rev. K • 8/20
Note: Refractory is Fragile.
Handle with care.
Figure 4.4 Side Refractory Removal
Note: The refractory must be removed
before removing the grate.
Figure 4.5 Grate Removal