Heat & Glo 6000CLX-IFT-S Owner's Manual page 19

Figure 4.2 IPI Pilot Flame Patterns
NOTE: Appearance of rock jig, pilot shield and media tray
may vary between appliance models.
L.E.D Replacement
Frequency: As needed
By: Qualified Service Technician
Tools needed: Protective gloves, replacement LED as-
semblies, 1/4 inch nut driver.
The LEDs installed in this appliance do not require any
annual service. However, the LED assemblies can be
replaced. To replace:
• Remove Logs, Grate/Burner, Base refractory.
• Remove the ember glass assembly. The LED box can
be lifted out of the fireplace at this point.
• See replacement parts list for LED part numbers.
Heat & Glo • 6000CLX-IFT, 8000CLX-IFT Owner's Manual • 2506-981 Rev. K • 8/20
Optional Black Glass Refractory
Frequency: Annually
By: Qualified Service Technician
Tools needed: Protective gloves, dust cloths, non-abra-
sive glass cleaner
CAUTION! Handle fixed glass assembly with care.
Glass is breakable.
• Avoid striking, scratching or slamming glass
• Avoid abrasive cleaners
• DO NOT clean glass while it is hot
• Remove decorative front from fireplace and set aside
on work surface.
• Pull the four glass assembly latches out of the groove
on the glass frame. Remove glass assembly from the
appliance See Figure 4.1.
Note: It may be necessary to remove logs in order to clean
and inspect the glass refractory. Reinstall logs using in-
structions included in appliance installation manual.
• Clean black glass refractory with a non-abrasive
commercially available cleaner.
- Light deposits: Use a soft cloth with soap and water
- Heavy deposits: Use commercial fireplace glass
cleaner (consult with your dealer)
• Carefully set fixed glass assembly in place on fireplace.
Hold glass in place with one hand and secure glass
latches with the other hand.
• Replace the glass assembly on the appliance. Pull out
and latch the four glass assembly latches into the groove
on the glass frame.
• Reinstall decorative front.
19