Heat & Glo 6000CLX-IFT-S Owner's Manual page 15

- Wait five (5) minutes to allow possible
accumulated gas to clear.
- Set the IFT-ECM 3-position selector switch to ON
or REMOTE position. Module will beep once and
flash a three GREEN LED code on successful
startup.
- If placed in ON position, the appliance will ignite
normally if the error condition was corrected.
- If placed in REMOTE position, use the paired IFT-
RC400, IFT-RC150 or wired wall switch to start
the appliance; appliance will ignite normally if the
error condition was corrected.
- If the IFT-ECM re-enters the lock-out condition
after these steps, call your dealer for service.
IntelliFire Touch Ignition System
NOTICE: Batteries should not be placed in the battery
pack while using the transformer. Remove batteries before
using the transformer, and unplug the transformer before
installing the batteries. Battery polarity must be correct or
module damage will occur.
Appliance ON/OFF:
This model is supplied with a fully functional remote
control. This remote controls:
• ON/OFF Functions
• Flame height adjustments
• Thermostat
• Electric Ember Bed
• LED Accent Lighting
• Cold Climate Feature
• Fan Speed
• Optional Heat Management System
Please refer to the instructions included with the remote
control for more detailed operating instructions.
LED Accent Lighting
• LED accent lighting is a standard feature on the
6000CLX-IFT-S, 8000CLX-IFT-S, 6000CLX-IFT-TG
and 8000CLX-IFT-TG models.
• The intensity of the LED accent lighting may be con-
trolled through the remote control included with your
fireplace.
• LED accent lighting is not available for the 6000CLX-
IFT-G and 8000CLX-IFT-G models.
Heat & Glo • 6000CLX-IFT, 8000CLX-IFT Owner's Manual • 2506-981 Rev. K • 8/20
LED Electric Embers
• LED Electric Embers are a standard feature on these
models.
• The intensity of the these embers may be controlled
through the remote control included with your fire-
place.
Heat Management Systems
Optional Heat-Zone -Gas Kit
®
The Heat-Zone -Gas heat management option is
®
available for use with the 6000CLX-IFT and 8000CLX-
IFT appliances. The Heat-Zone
your fireplace to an adjacent room in your home, up to 20
feet away.
Optional Heat-Out-Gas Kit
The Heat-Out-Gas heat management option is available
for use with the 6000CLX-IFT and 8000CLX-IFT
appliances and must be used in conjunction with the IFT-
RC400 remote control. The Heat-Out-Gas kit draws heat
from your fireplace and directs it outside, up to 25 feet
away.
Optional Heat-Duct Kit
The Heat-Duct heat management option is available for
use with the 6000CLX-IFT and 8000CLX-IFT appliances.
The Heat-Duct redistributes heat from the fireplace via
the furnace ductwork.
-Gas Kit draws heat from
®
15