Yamaha PHAZER PZ50X Supplementary Service Manual page 89

1 To the main switch
2 To the main switch
3 To the fuel sender
4 Route the wire harness over the
frame rear cross member.
5 To the multi-function meter unit
6 Brake hose
7 Coolant reservoir breather hose
8 Wire harness
9 Fasten the wire harness at the
white tape to the frame rear
cross member with the plastic
band. Install the plastic band with
its buckle positioned on top of
the wire harness and its end fac-
ing to the left.
0 Oil level switch coupler
A Oil tank breather hose
B Radiator outlet pipe
C Radiator fan motor coupler
D Knock sensor coupler
E Radiator inlet hose
F Fasten the wire harness, radiator
fan motor lead and knock sensor
lead to the radiator outlet pipe
with the plastic band, making
sure to align the radiator fan
motor coupler with the wire har-
ness joint coupler. Install the
plastic band with its buckle posi-
tioned to the outside of the pipe
and its end facing rearward.
G Coolant temperature sensor cou-
pler
H Fasten the wire harness and
radiator fan motor lead to the
radiator outlet hose with the plas-
tic band. Install the plastic band
with its buckle positioned to the
outside of the hose and its end
facing rearward.
CABLE ROUTING
83
SPEC