Yamaha PHAZER PZ50X Supplementary Service Manual page 66

Parts to be tightened
Front pivot arm and connecting arm
Front pivot arm and sliding frame
Front suspension bracket and connecting arm
Sliding frame and wheel bracket
Suspension wheel
Front suspension bracket shaft and sliding frame
Set bolt (wheel bracket)
Shock absorber and connecting arm
Pull rod, shock absorber, and rear suspension
bracket
Rear suspension bracket shaft and sliding frame
Rear pivot arm and pull rod
Shock absorber and rear pivot arm
2-up adjusting block
Set bolt (collar)
Rear pivot arm joint
Rear pivot arm and rear pivot arm bracket
Rear pivot arm bracket and sliding frame
Rear pivot arm bracket stopper and sliding frame
Wheel bracket, shaft, and sliding frame
Rear pivot arm and control rod stopper
Control rod adjusting locknut
Control rod shaft and sliding frame
Rear axle
Set bolt (front axle)
Bearing holder (front axle)
Bearing holder (front axle)
Speed sensor
Bearing housing
Gear unit (speed sensor)
NOTE:
Tightening steps:
1. Tighten the bolt to a torque at 120 Nm (12.0 m · kg, 85 ft · lb).
2. Loosen the bolt completely.
3. Retighten the bolt to a torque of 60 Nm (6.0 m · kg, 43 ft · lb).
TIGHTENING TORQUE
Tightening torque
Nm m · kg ft · lb
72 7.2 52 (PZ50VT/PZ50MP)
60 6.0 43
72 7.2 52
72 7.2 52 Apply LOCTITE
(PZ50MT)
60 6.0 43
60 6.0 43
6 0.6 4.3
49 4.9 35 (PZ50/PZ50GT/PZ50RT/PZ50MT)
49 4.9 35 (PZ50VT/PZ50MP)
60 6.0 43 (PZ50VT/PZ50MP)
49 4.9 35 (PZ50VT/PZ50MP)
49 4.9 35
60 6.0 43 (PZ50VT/PZ50MP)
9 0.9 6.5 (PZ50VT/PZ50MP)
35 3.5 25 (PZ50/PZ50GT/PZ50RT/PZ50MT)
72 7.2 52 Apply LOCTITE
(PZ50/PZ50GT/PZ50RT/PZ50MT)
72 7.2 52 Apply LOCTITE
(PZ50/PZ50GT/PZ50RT/PZ50MT)
60 6.0 43 (PZ50/PZ50GT/PZ50RT/PZ50MT)
60 6.0 43 (PZ50MT)
60 6.0 43 (PZ50VT/PZ50MP)
25 2.5 18 (PZ50VT/PZ50MP)
72 7.2 52 (PZ50VT/PZ50MP)
75 7.5 54
9 0.9 6.5 Apply LOCTITE
24 2.4 17 Inside
24 2.4 17 Apply LOCTITE
Outside
24 2.4 17
24 2.4 17
40 4.0 29
60
SPEC
Remarks
®
®
®
®
®