Yamaha PHAZER PZ50X Supplementary Service Manual page 81

1 Injector coupler
2 Cylinder head breather hose
3 Reverse position switch coupler
(PZ50GT/PZ50RT/PZ50MT/
PZ50VT/PZ50MP)
4 Drive position switch coupler
(PZ50GT/PZ50RT/PZ50MT/
PZ50VT/PZ50MP)
5 Fasten the reverse position
switch lead to the coolant reser-
voir tank with the plastic band.
Install the plastic band with its
buckle positioned on top of the
coolant reservoir tank and its end
facing to the right. (PZ50GT/
PZ50RT/PZ50MT/PZ50VT/
PZ50MP)
6 Sub-wire harness
7 Gear motor (Except for PZ50)
8 Gear motor coupler (PZ50GT/
PZ50RT/PZ50MT/PZ50VT/
PZ50MP)
9 Fuel tank breather hose
0 Wire harness
A Fasten the wire harness and fuel
tank breather hose to the frame
rear cross member with the plas-
tic band, making sure to fasten
the hose before and after the
bend in the hose.
B Cylinder #1 ignition coil lead
C Route the wire harness under the
frame rear cross member.
D Fasten the cylinder identification
sensor lead to the cylinder head
cover with the plastic band.
E Cylinder identification sensor
lead coupler
F To the auxiliary DC jack
(PZ50GT/PZ50RT/PZ50MT)
CABLE ROUTING
75
SPEC