Yamaha PHAZER PZ50X Supplementary Service Manual page 77

PZ50VT/PZ50MP
1 To the coolant temperature sen-
sor
2 To the knock sensor
3 Pass the plastic band through
the hole in the frame front cross
member, and then fasten the
wire harness with the band. Posi-
tion the buckle of the plastic
band on top of the leads, with the
end facing to the left.
4 Headlight lead coupler
5 Wire harness
6 Radiator fan motor lead coupler
7 To the oil level switch
8 Right handlebar switch lead cou-
plers
9 Route the fuel hose and sub-wire
harness over the wire harness
and fuel tank breather hose.
0 Fasten the wire harness, parking
brake cable, and brake hose to
the frame rear cross member
with the plastic band.
A Fasten the wire harness and fuel
tank breather hose to the frame
rear cross member with the plas-
tic band.
B To parking brake
C Fuel tank breather hose
D Main switch
E Tail/brake light harness coupler
F To the brake caliper
G Throttle cable
H To the tail/brake light
I Fuel pump lead
J Fuel hose
K Fasten the fuel pump lead at the
white tape to the fuel hose with
the plastic band.
L Fuel pump coupler
M Fuel pump
N To the multi-function meter
CABLE ROUTING
71
SPEC