Removing And Installing The Inside Door Seal - Skoda Rapid NH 2014 Workshop Manual

Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
2.21 Removing and installing the inside door
seal
During the installation in series, the inside door seals are provided
with a sealing compound which is placed on the door flange and
subsequently rolled up.
Note
During the removal of the seal, the sealing mass is distributed
♦
on the inside of the seal. While doing so, the sides are slightly
bent open. If the seal is re-installed, leak-tightness and tight fit
can no longer be guaranteed.
For this reason, each seal which was completely removed
♦
must be replaced with a so-called "hammer finish seal".
If the seals were detached partially, press together the sides
♦
of the seal before installing.
Removing and installing is only carried out for the right inside
♦
door seal. The same applies therefore when removing and in‐
stalling the left inside door seal.
124
Rep. gr.58 - Rear doors, door components