Glueing The Retaining Plate For The Interior Rear-View Mirror - Skoda Rapid NH 2014 Workshop Manual

1.2.2 Removing interior rear-view mirror with
rain and light detector sensor
Removing
– Switch off the ignition and all electrical components.
– Unclip cable cover -2-.
– Unclip cover -4- from the retaining plate.
– Turn mirror -3- 20° anticlockwise.
– Remove mirror -3- from retaining plate -5-.
– Disconnect connector -1- from plug connection.
Installing
– Insert connector -1- into plug connection.
– Turn mirror -3- 20° anticlockwise and position to retaining plate
-5-.
– Ensure the mirror is seated parallel and turn clockwise until it
locks into place.
– Install cap -4-.
– Install cable cover -2-.
Removing retaining plate for interior mirror with sensor for rain
and light detection
Note
The retaining plate for interior mirror with sensor for rain and light
detection cannot be glued on under workshop conditions. Is part
of the windscreen.
1.3 Glueing the retaining plate for the interi‐
or rear-view mirror
1.3.1 Materials
♦ Glass metal adhesive kit - D 000 703 A1-
Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
199
1. Interior rear-view mirror