Skoda Rapid NH 2014 Workshop Manual page 39

1.9.2 Removing and installing
Removing
– Tighten the operating lever -1- and unlock the bonnet.
– Fit a small screwdriver into the gap between the operating
lever - 1 - and the retaining clip - 2 -.
– Lever the retaining clip -2- out of the operating lever (Pos. 1)
-arrow- and detach the operating lever from the bearing brack‐
et -3-.
When carrying out further work on the bearing bracket - 3 -, re‐
move the bottom A pillar trim panel - 4 -.
Installing
• The bottom A pillar trim panel -4- is installed.
– Push the retaining clip -2- into the operating lever.
– Press the operating lever - 1 - onto the bearing bracket - 3 -.
Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
31
1. Front flap