Table of Contents
Advertisement
2
Installing the Bagger Adapter
Parts needed for this procedure:
1
Adapter
2
Screw (1/2 x 3-1/2 inches)
2
Locknut (1/2 inch)
Procedure
Install the adapter onto the hitch of the machine with 2
screws (1/2 x 3-1/2 inches) and 2 locknuts (1/2 inch) as
shown in
Figure
3.
Note: To install the hitch, refer to the hitch kit installation
instructions.
1. Adapter
2. Screw (1/2 x 1-3/4 inches)
3
Installing the Hood Assembly
and Bags
Parts needed for this procedure:
1
Hood assembly
3
Bag
2
Pin and hairpin-cotter assembly
Figure 3
3. Hitch
4. Locknut (1/2 inch)
Procedure
1. Position the hood assembly on its back.
2. Slide the hooks onto the lower mounting bracket (A
of
Figure
4).
3. Rotate the hood assembly onto the lower bagger
mounting bracket (B of
4. Align the hole in the bagger with the upper mounting
bracket (C of
Figure
5. Install the pin and secure it with the hairpin cotter on
both sides (C of
5
Figure
4).
4).
Figure
4).
Figure 4
Advertisement
Table of Contents
