Advertisement
5.
Secure the flasher using a cable tie
6.
Plug the harness into the rocker switch and
multi-function switch
Figure 8
1. Rocker switch connector
2. Relay connector
3. Flasher connector
7.
Plug the wire harness into the relay and flasher
(Figure
8).
(Figure
(Figure
8).
4. Switch connector
5. Cable tie
8).
8.
Loosen the bolts around the steering-column
base
(Figure
9.
Raise the base up and drill a 22 mm (7/8 inch)
hole as shown in
1. Steering-column base
10.
Route the harness through the hole you drilled
in the base.
11.
If the machine is used in North America, connect
the bullet connectors as shown in
Note:
Do not connect the bullet connectors if
the machine is used outside of North America.
g319850
1. Not connected—for
non-North America
machines
5
9).
Figure
9.
Figure 9
Figure
Figure 10
2. Connected—for North
America machines
g304296
10.
g319849
Advertisement
