Toro 31984 Installation Instructions

USB Charging Kit
Groundsmaster
Model No. 31984
Installation
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Lower the cutting unit.
4. Shut off the engine and remove the key.
5. Disconnect the battery; refer to the electrical
system maintenance section of your Operator's
Manual.
2
Installing the Kit
Parts needed for this procedure:
1 USB port
4 Plug
Procedure
1. Remove the existing plugs
sides of the parking-brake cover.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® 3200 or 3300 Series Traction Unit
(Figure 1) from both
Register at www.Toro.com.
Figure 1
1. Plugs (4 total—2 shown)
2. Remove the parking-brake cover from the
machine.
3. Drill a hole (3 cm or 1-3/16 inches) into the front
of the cover as shown in
Original Instructions (EN) All Rights Reserved *3434-891* A
Printed in the USA
Form No. 3434-891 Rev A
Installation Instructions
Figure 2
g301501