Advertisement
9.
Secure the assembled slow-moving vehicle sign
to the hood using 4 flange-head bolts (1/4 x 3/4
inch), 2 back mounts, and 4 locknuts (1/4 inch)
as shown in
Figure
1. Assembled slow-moving
vehicle sign
2. Flange-head bolt (1/4 x
3/4 inch)
10.
Apply 2 red reflective tape to the rear bumper
and 1 reflective tape to each light housing using
the dimensions shown in
32.
1. 9.7 to 15.7 mm (3/8 to 5/8
inch)
30.
Figure 30
3. Back mount
4. Locknut (1/4 inch)
Figure 31
and
Figure 31
2. 11.7 to 17.8 mm (7/16 to
11/16 inch)
1. 28.7 to 34.8 mm (1-1/8 to
1-3/8 inches)
6
g304127
Routing the Light Wire
Harness
Parts needed for this procedure:
Figure
1
Light wire harness
2
Cable tie
2
Inner mount assembly
2
Taillight
4
Pan-head screw (#10 x 1-1/4 inches)
4
Flange nut (#10)
8
Button-head bolt (1/4 x 3/4 inch)
g304126
Procedure
Refer to the following figures and instructions for
routing the light wire harness.
12
Figure 32
2. 22.4 to 28.4 mm (7/8 to
1-1/8 inches)
g304125
Advertisement
