Table of Contents
Advertisement
4
Mount the Parking Brake
Switch
Parts needed for this procedure:
1
Parking brake switch
2
Screws
Procedure
1. Mount the parking brake switch to the parking brake
mount with two screws as shown in Figure 5.
1. Switch
2. Plug switch wire connector into lift wire connector
harness.
3. Remove the loop back connector from the vehicle
wire harness labeled 1/3 lift. Connect the lift wire
harness to the vehicle wire harness.
5
Mount Rear Level Switch
Parts needed for this procedure:
1
Rear level switch bracket
1
Rear level switch w/ harness
For Workman 3000–4000 series
vehicles with serial numbers 240000001
and up
1. Remove the locknuts securing the top of the hitch
plate to rear axle (Figure 6). Using the upper set of
Figure 5
mounting holes, mount the level switch bracket to
rear axle with the locknuts previously removed.
1. Hitch plate
2. Route switch harness forward, along differential
lock cable to left side of machine. Harness must not
interfere with any hot (exhaust) or moving parts.
Secure harness to differential lock cable with cable
ties.
For Workman HD, HDX and HDX-D
vehicles
1. Remove the capscrews securing the hitch plate to the
rear axle (Figure 7). Using the lower set of mounting
holes, loosely mount 2 washers and level switch
bracket to rear axle with the capscrews previously
removed. The washers are to be positioned between
the hitch plate and axle. Tighten all four capscrews.
9
G016822
Figure 6
2. Level switch bracket
Advertisement
Table of Contents
