Table of Contents
Advertisement
Figure 18
1. Safety lock (2)
DANGER
Platform lift can crush and cause personal
injury.
• Never work under raised platform without
lift safety locks engaged.
• Never use safety blocks to support a load
on lift.
7. Press "DOWN" button on pendant control and
lower lift until rollers gently contact safety locks.
Once the locks are fully engaged with the scissors
rollers, continue to hold the "DOWN" button for
5-10 seconds to relieve the pressure within the
hydraulic circuit
8. To remove safety locks:
• Raise lift slightly.
• Return safety locks to storage position.
2
1
G016813
2. Scissors roller (2)
Operating the Lift
The 1/3 platform lift is designed to be used only with
a Workman Vehicle and must be mounted with the
wiring harness, level, decals, switches and all interlock
switches installed.
DANGER
Improper operation of platform lift may cause
serious personal injury or death. To reduce risk to
operator and bystanders:
• Read and understand all safety instructions
in Workman and Platform Lift Operator's
Manuals and warning labels.
• Never use a platform lift without proper training
and authorization.
The electrical control system of the lift requires the
vehicle to be parked on a slope of less than a 5 degree
angle, parking brake engaged and the vehicle key in the
"ON" position with the engine off in order to activate
the lift circuit.
Operating
1. Set parking brake and chock wheels.
2. Rotate vehicle key switch to "ON" position with
the engine "OFF".
3. Climb into platform and secure safety chains across
entry.
4. Grasp pendant control and rotate lift key switch to
"On" position.
5. Press "UP" button to raise lift; "DOWN" button
to lower lift (Figure 19).
Note: If the oil in the vehicle engine is cold, it may
take several seconds for the engine oil pressure to
bleed down after the engine is turned off. The lift
will not operate until the oil pressure indicator light
is on.
WARNING
Operation of platform lift without parking brake
engaged can result in tip-over and personal
injury.
• Always apply parking brake before operating
platform lift. The use of wheel chocks is
recommended.
• Do not release parking brake while platform
lift is raised.
• Do not raise the platform lift if the bubble is
outside of the operating region on the level
indicator.
15
Advertisement
Table of Contents
