Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
Media and Additional Parts
Description
Key
Operators Manual
Parts Catalog
The 1/3 platform lift is designed to be used only with a
Workman Vehicle and must be mounted with the wiring
harness, level, decals, switches and all interlock switches
installed. The 1/3 platform lift will only work on
Workman 3000–4000 series vehicles with serial numbers
240000001 and up and all Workman HD, HDX and
HDX-D vehicles.
Description
No parts required
No parts required
Main Wire Harness w/ Relays
Cable Tie
Screw, 1/4 x 3/4 inch
Nut, 1/4 inch
Fuse
Parking brake switch
Screws
Rear level switch bracket
Rear level switch w/ harness
No parts required
Reinforcing Plate
Flange HD. Capscrew, 3/8 x 1 inch
Flangenut, 3/8 inch
No parts required
No parts required
Circular Bubble Level
Operation Decal
No Step Decal
Qty.
–
–
1
7
2
2
1
1
2
1
1
–
2
4
4
–
–
1
1
2
Qty.
Use the key to unlock the pendant control to authorize the
1
use of lift
1
Read before operating the lift
1
Use to reference part numbers
6
Use
Remove the seat, shroud and fender
assemblies
Remove the hood
Install main wire harness w/relays
Mount the Parking Brake Switch
Mount rear level switch
Reinstall hood
Mount lift onto vehicle frame
Connect wires
Reconnect battery
Mount circular bubble level
Install decals
Use