Installing The Weights For A 52-Inch; Bagger; Adjusting The Parking Brake - Toro E-Z Vac Z Master Z400 Series Operator's Manual

11
Installing the Weights for a
52-inch Bagger
Parts needed for this procedure:
2 Weight
2 Bolt (3/8 x 3 inches)
2 Locknut (3/8 inch)
4 Washer (3/8 inch)
Procedure
To comply with ANSI/OPEI B71.4-2012 Standard, add front
weight to the machine.
CAUTION
The bagger adds a lot of weight to the rear of the
machine and may cause an unstable condition
which could result in a loss of control.
1. Install 2 bolts (3/8 x 3 inches) and 2 washers (3/8 inch)
to the frame under the foot rest
2. Install the weights, with the decal facing the front, to
the bolts with 2 washers (3/8 inch) and locknut (3/8
inch) under the frame
(Figure 34).
(Figure 34).
1. Bolt, (3/8 x 3 inches)
2. Washer, (3/8 inch)
3. Frame
12

Adjusting the Parking Brake

No Parts Required
Procedure
Check to make sure the parking brake is adjusted properly.
Refer to your Operator's Manual for the correct procedure.
17
Figure 34
4. Weight
5. Locknut, (3/8 inch)
6. Decal on the weight
positioned to the front of
the machine