Table of Contents
Advertisement
9
Installing the Belt Cover
No Parts Required
Procedure
1. Lower the mower deck to the lowest height-of-cut
position.
2. Install the new belt cover so the notches on both sides
go over the belt cover supports and secure the latch
(Figure
32).
Figure 32
1. Belt cover
2. Blower assembly
3. Pulley assembly
4. Hole for latch
5. Latch
6. Belt cover notch
7. Belt cover support
10
Installing the Weight for a
48-inch Bagger
Parts needed for this procedure:
1
Weight
2
Bolt (3/8 x 2 inches)
2
Locknut (3/8 inch)
4
Washer (3/8 inch)
Procedure
To comply with ANSI/OPEI B71.4-2012 Standard, add front
weight to the machine.
CAUTION
The bagger adds a lot of weight to the rear of the
machine and may cause an unstable condition
which could result in a loss of control.
1. Install 2 bolts (3/8 x 2 inches) and 2 washers (3/8 inch)
to the frame under the foot rest
2. Install the weight, with the decal facing the front, to
the bolts with 2 washers (3/8 inch) and locknut (3/8
inch) under the frame
1. Bolt (3/8 x 2 inches)
2. Washer (3/8 inch)
3. Frame
16
(Figure
33).
(Figure
34).
Figure 33
4. Weight
5. Locknut (3/8 inch)
6. Decal on the weight
positioned to the front of
the machine
Advertisement
Table of Contents
